- MORE LUMENS - 20-30% more lumens than magnetic ballasts
- Lumatek ballasts are 8-15% BRIGHTER than other brands on the market
- COMPLETELY SILENT - leave the humming and buzzing behind
- BEST WARRANTY IN THE INDUSTRY 3 years - Full Warranty PLUS 2 years - Prorated
- SMALL COMPACT DESIGN - under 10 pounds
- COMPLETELY SEALED from the inside and water resistant
- FAST START UP - reaches full brightness in under a minute
- NO FANS - Resin sealed industrial case to ensure reliability
- CUT-OFF-CIRCUITRY - Automatically shuts off in case of short
- RELIABLE - every ballast is factory tested for 12 hours
- Dual Voltage - 120V and 240V
- RF SHIELDED output cord
- MICROPROCESSOR-CONTROLLED to ensure proper performance with every bulb
- Dimmable - From 50% all the way up to Super Lumens 110%!

Lamp Compatibility
The Lumatek ballast is a high performance product that is designed to work with most high quality lamps. Cheap inferior lamps may cause problems and Lumatek recommends only high quality American or European lamps. One or two good lamps with very high strike voltages may also be difficult for any electronic ballast to light; Lumatek has an adaptor available for those lamps.
Lamp Replacement
Be sure to disconnect the power source before changing lamps. Always use the specified wattage of lamp. (A 400W lamp should not be used in a 600W ballast). Lumatek recommends lamp replacement every 6-12 months.
Hot Re-Strike
It is VERY important that the lamp is given adequate time to cool down before it is reignited. You should allow a hot lamp to cool for 20-30 minutes before you try to re-strike it. Hot re-strikes cause premature lamp failure and lumen output degradation. Additionally, the lamp should never be turned off before the lamp reaches full intensity.
R.F Emissions
Lumatek ballasts are now internally RF shielded and can be used with standard System Cord sets as available in each country worldwide. Lumatek ballasts produce the least amount of EMI (electro- magnetic interference) of any electronic ballast and conform to all international Electro-magnetic emission standards. This applies to all blue and purple models of the Lumatek. The older silver models which employed earlier technology (at the time industry leading) can be upgraded for current models (and the highest EMI standards) at reduced purchase costs; for details please contact Lumatek directly.
Super-Lumen Switch
Lumatek ballasts include the industry first “super lumen switch”. This feature will boost lumen output by 10% when the switch is activated. This allows unprecedented control of lumen output during ballast use. This feature is for HPS lamps only.
Mounting Location
Do not install ballasts in areas of very high heat such as an attic or a closed closet. Do not mount the ballast to the reflector or blow exhaust air over them. Do not stack ballast on top of each other. Do not allow contact with water. Mount units at least six inches apart. If a unit has any leaking resin please relocate to a cooler area or place a fan near the ballasts.